H35-561 Dumps for Pass Guaranteed - Pass H35-561 Exam 2022
H35-561 Exam Dumps - Try Best H35-561 Exam Questions from Training Expert ActualTorrent
NEW QUESTION 15
For FDD, which of the following time slots are the primary synchronization signals transmitted? (Multiple choice)
- A. TS10
- B. TS0
- C. TS1
- D. TS11
Answer: A,B
NEW QUESTION 16
What are the types of TDD uplink and downlink subframe configurations?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 17
LTE networking can use the same frequency or different frequency, which of the following statements is wrong?
- A. 10M co-frequency networking is more obvious than inter-cell interference compared to 3*10M inter-frequency networking.
- B. 10M co-frequency networking can use resources more efficiently than 3*10M inter-frequency networking to improve spectrum efficiency.
- C. 10M co-frequency networking can increase the rate of edge users compared to 3*10M inter-frequency networking.
- D. 10M co-frequency networking is more difficult to optimize than 3*10M inter-frequency networking.
Answer: C
NEW QUESTION 18
In the quick analysis mode, how much data can the Assistant project process at most?
- A. 2GB
- B. 5GB
- C. 10GB
- D. 1GB
Answer: C
NEW QUESTION 19
Regarding the different system redirection, which of the following descriptions is wrong?
- A. Measurement-based redirection is the measurement of the target cell using the B2 event of PSH0
- B. The redirection execution needs to send a handover request to the neighboring cell with the highest blind priority.
- C. Blind redirection only measures the signal strength of the serving cell itself, and does not detect the signal strength of the redirected target cell.
- D. Redirection is divided into blind redirection and measurement-based redirection
Answer: B
NEW QUESTION 20
How many subframes are there in an LTE radio frame?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION 21
Which of the following is wrong about the TDM eICIC statement?
- A. ABS (Almost Blank Subframe) refers to not transmitting user specific PDCCH and PDSCH on certain subframes of a cell, because these two types of channels occupy most of the resources (CCE and RB) of each subframe, so Such a subframe is called an ABS subframe.
- B. TDM eICIC is a HetNet interference coordination solution
- C. The microcell schedules interference UE in the normal subframe of the macro station
- D. The microcell schedules interfering UE in the macro station ABS subframe
Answer: D
NEW QUESTION 22
For the single-station verification link, if the UE can access the network but cannot switch, which of the following steps can be taken to troubleshoot the cause? (Multiple choice)
- A. Check if the switching threshold is correct
- B. Check if the attachment is normal
- C. Check if the neighboring area is configured
- D. Check if the wireless signal is good, whether the RSRP and SINR values are too small, such as the reference value (RSRP > -90dBm, SINR > 5dB)
Answer: A,C
NEW QUESTION 23
The air interface paging message includes a field (CS or PS) indicating the source of the paging, an E flag, and a location-dependent TA.
- A. True
- B. False
Answer: A
NEW QUESTION 24
Which of the following parameter settings distinguishes between CCU users and CEU users?
- A. CellSpecificOffset=-10dB
- B. IntraFreqHoA3Hyst=-10dB
- C. UlCompA30ffset=-10dB
- D. CellQoffset=-10dB
Answer: B
NEW QUESTION 25
Carrier aggregation, if basic scheduling is used, on PCe11 and SCe11, CAUE is regarded as an independent one to allocate resources, and the CAE rate is higher than non-CAE.
- A. True
- B. False
Answer: A
NEW QUESTION 26
What are the measurement configuration messages of the E-UTRAN to UTRAN system handover based on coverage? (multiple choice)
- A. Measuring time
- B. UTRAN FDD filter coefficient
- C. Measure GAP configuration
- D. Measuring object
Answer: B,C,D
NEW QUESTION 27
Which of the following is a timer for periodic TAU?
- A. T3212
- B. T3412
- C. T3413
- D. T300
Answer: B
NEW QUESTION 28
Regarding the re-election of the community, which of the following statements are correct? (Multiple choice)
- A. The priority of the inter-frequency neighboring area must be different from the serving cell
- B. The larger the neighboring cell offset value CellQoffset, the harder it is to reselect the cell.
- C. Same frequency neighbors have the same priority
- D. The serving cell and the inter-frequency system neighboring cell reselection priority are sent to the UE through the system message in the cell broadcast.
Answer: B,C,D
NEW QUESTION 29
What are the conditions for reselecting E-UTRAN or different system frequency cells with lower priority than the serving cell? (Multiple Choice)
- A. The cell of the service frequency or the equal priority E-UTRA frequency does not satisfy the reselection criteria.
- B. Within the time interval TreselectionRAT, SServingCe11<Threshserving,low (service carrier low threshold) and low priority E-UTRAN have a cell SnonServingCe11,x>Threshx,low
- C. The E-UTRAN frequency or the different system frequency of the cell with higher priority than the service frequency does not satisfy the reselection criterion.
- D. The UE stays in the current serving cell for more than 1 s.
Answer: A,B,C,D
NEW QUESTION 30
Prior to R10, only QPSK, 16QAM, and 64QAM modulation modes were supported. The R12 protocol supports downlink 256QAM.
- A. True
- B. False
Answer: A
NEW QUESTION 31
Which of the following channel or signal is used to cell PCI identification and cell search process?
- A. PSS/SSS
- B. PDCCH
- C. PDSCH
- D. PCRCH
Answer: A
NEW QUESTION 32
Which of the following devices is the core of the multimedia module, responsible for registration authentication, session control, and service triggering of the terminal?
- A. S-CSCF: Service CSCF
- B. PCRF
- C. P-CSCF: Proxy CSCF
- D. I-CSCF: Query CSCF
Answer: A
NEW QUESTION 33
What is the maximum effective coverage vertical lob Width of the 706.64T64R antenna?
- A. 65 degrees
- B. 17 degrees
- C. 35 degrees
- D. 6.5 degrees
Answer: D
NEW QUESTION 34
Which network element does the service flow template TFT work on? (Multiple Choice)
- A. P-GW
- B. eNodeB
- C. UE
- D. S-GW
Answer: A,B,C,D
NEW QUESTION 35
Which of the following control signalings for uplink PUCCH feedback? (multiple choice)
- A. PMI
- B. cQI
- C. Qos
- D. RI
Answer: A,B,D
NEW QUESTION 36
The LTE cell search is performed when the mobile phone is powered on, based on the primary synchronization signal and the auxiliary synchronization signal.
- A. True
- B. False
Answer: A
NEW QUESTION 37
What is wrong description about handover in LTE of the following?
- A. It can trigger relay switching or trigger hard switching
- B. The same frequency or polit frequency handover depending on whether the serving cell and the target cell have the same center frequency.
- C. The parameters sent to the terminal about the measurement object and related events are in the same message.
- D. The UE reports that the measurement report is still an independent message.
Answer: D
NEW QUESTION 38
About TDD and FDD contrast description, which is correct?
- A. The subframe ratio of LTE TDD makes the delay of some information feedback (such as HARQ ACK/NACK, or CQI) less than the delay of LTE FDD. Therefore, the RTT (Round-trip Time) of LTE TDD is slightly smaller than LTE FDD.
- B. Since the LTE TDD in GP present in such LTE TDD spectral efficiency slightly lower than LTE FDD.
- C. LTE TDD is a time division system. When the terminal is allocated the same number of RB, the LTE TDD throughput rate is lower than the LTE FDD.
- D. For 20MHz bandwidth cell, the FDD uplink and downlink each occupy 20MHz, and the TDD uplink and downlink share 20MHz.
Answer: A,B,D
NEW QUESTION 39
......
Latest 100% Passing Guarantee - Brilliant H35-561 Exam Questions PDF: https://passking.actualtorrent.com/H35-561-exam-guide-torrent.html