Pass Your Huawei Exam with H35-561-ENU Exam Dumps (Updated 62 Questions) [Q11-Q35]

Share

Pass Your Huawei Exam with H35-561-ENU Exam Dumps (Updated 62 Questions)

H35-561-ENU Exam Dumps - Huawei Practice Test Questions

NEW QUESTION 11
What are wrong descriptions of LTE signal quality? (Multiple choice)

  • A. The higher the average value of QCI, the better the signal quality.
  • B. The higher the CQI value, the better the signal quality.
  • C. The MCS value is assigned by the MME and indicates the quality of the Uu interface.
  • D. The UE can report the quality of each PRB separately.

Answer: A,C,D

 

NEW QUESTION 12
The PCI plan is only for the same-frequency neighboring area. If it is an inter- frequency neighboring area, you can use the same PCI directly without considering the PCI planning.

  • A. True
  • B. False

Answer: A

 

NEW QUESTION 13
LTE cell ID planning by eNBID and cellID cells including ID in the whole network only, which statement is correct?

  • A. Unique in the same PLMN
  • B. Unique in the same MME
  • C. Unique in the same TA
  • D. Unique in the same TAL

Answer: A

 

NEW QUESTION 14
Regarding the power control in the LTE system, what are the correct descriptions of the following? (Multiple Choice)

  • A. Power control can improve coverage and capacity
  • B. Power control is one of the functions in the MAC layer
  • C. The purpose of power control is to save energy
  • D. Power control is to ensure the quality of service

Answer: A,C

 

NEW QUESTION 15
Which of the following radio bearers can carry MAS messages? (Multiple Choice)

  • A. SRB0
  • B. SRB2
  • C. SRB1
  • D. SRB3

Answer: B,C

 

NEW QUESTION 16
Regarding the CSFB to GSM heterogeneous system neighborhood planning principles, which of the following are correct?

  • A. Coverage generally refers to the GSM900MHz band
  • B. Can draw on the 2G neighboring configuration of the 3G network for planning
  • C. Priority to add co-site cells and the first layer to the adjacent area
  • D. Priority in capacity planning based on capacity planning

Answer: B,C,D

 

NEW QUESTION 17
What are the correct adjustment principles for RE and ABS in the TDM eICIC program?

  • A. RE adjustment is often used to make fast changes, ABS adjustment is often used to make slow changes
  • B. ABS adjustment will change the resources of the macro cell and the micro cell, and will take effect immediately when the next TTI schedules the user.
  • C. RE and ABS adjustments should follow user distribution and load distribution in the network
  • D. RE adjustment causes inter-cell handover to achieve balanced user objectives

Answer: A,C,D

 

NEW QUESTION 18
When the cellular network is used, which of the following is the station spacing company of the three-sector base station?

  • A. 1.949R
  • B. 2R
  • C. 1.5R
  • D. 1.732R

Answer: C

 

NEW QUESTION 19
Which of the following core network elements does CSFB have?

  • A. MSC
  • B. PGW
  • C. MME
  • D. SGW

Answer: A,C

 

NEW QUESTION 20
Which of the following options can improve the VOLTE uplink coverage technology? (Multiple Choice)

  • A. RLC segmentation
  • B. TTI bundling
  • C. ROHC
  • D. Semi-static scheduling

Answer: A,B,C,D

 

NEW QUESTION 21
Which of the following are single site verified projects? (Multiple choice)

  • A. LTE access function test
  • B. LTE transmission test
  • C. LTE FTP service function test
  • D. LTE ping service function test

Answer: A,B,C,D

 

NEW QUESTION 22
NB-IoT downlink packet loss rate indicator is relatively high, what are the possible reasons?

  • A. UE inactivity timing setting is too large
  • B. Uplink interference
  • C. Weak coverage
  • D. Too many initial iterations of PDSCH

Answer: B,C

 

NEW QUESTION 23
What is the minimum measurement period for the performance measurement task?

  • A. 15 minutes
  • B. 30 minutes
  • C. 5 minutes
  • D. 60 minutes

Answer: A

 

NEW QUESTION 24
Which of the following scenarios will release the NAS signaling connection after the TAU is completed?

  • A. TAU initiated in IDLE state, Active flag=1
  • B. TAU initiated in the IDLE state, Active flag=0
  • C. TAU initiated under CONNECTED, Active flag=1
  • D. TAU initiated under CONNECTED, Active flag=0

Answer: B

 

NEW QUESTION 25
Which of the MIMO system gains listed below are obtained using the relative independence of spatial channel fading? (Multiple choice)

  • A. Array gain
  • B. Spatial multiplexing gain
  • C. Interference suppression gain
  • D. Diversity gain

Answer: B,D

 

NEW QUESTION 26
LTE power control does not affect the coverage and capacity of the system.

  • A. True
  • B. False

Answer: B

 

NEW QUESTION 27
RoHC can be used to compress the IP/UDP header of VoIP service packets to improve the efficiency of wireless transmission.

  • A. True
  • B. False

Answer: A

 

NEW QUESTION 28
Regarding NB-IoT, which of the following descriptions are correct? (Multiple choice)

  • A. Longer DRX and paging cycles are required to save power
  • B. NB-IoT supports 3 different deployment modes, namely independent deployment, protection band deployment, and in-band deployment.
  • C. Need large bandwidth to meet demand
  • D. Currently, TDD LTE system does not support NB-IoT technology.

Answer: A,B,D

 

NEW QUESTION 29
In the LTE synchronization process, what signal is achieved by frame synchronization and time synchronization respectively?

  • A. RS
  • B. PBCH
  • C. SSS
  • D. PSS

Answer: C,D

 

NEW QUESTION 30
Which process is used in the IMS registration process for the SCSCF download user Ifc?

  • A. UDR/UDA
  • B. MAR/MAA
  • C. SAR/SAA
  • D. UAR/UAA

Answer: C

 

NEW QUESTION 31
In the LTE system, the UE does not trigger a TA update when moving between multiple TAs belonging to the same TA LIST.

  • A. True
  • B. False

Answer: A

 

NEW QUESTION 32
Which of the data does not need to be collected when troubleshooting the RRC connection success rate?

  • A. Antenna model
  • B. Problem cell history alarm and current status
  • C. Cell carrier performance statistics
  • D. UE call failure CallTrace signaling tracking

Answer: A

 

NEW QUESTION 33
Which of the following channels must be used when an LTE user uploads a file? (Multiple choice)

  • A. PRACH
  • B. PUSCH
  • C. PDCCH
  • D. PDSCH

Answer: B,C,D

 

NEW QUESTION 34
Which of the following boards can measure CPU utilization? (Multiple Choice)

  • A. LBBP
  • B. UMPT
  • C. LMPT
  • D. RRU

Answer: A,C,D

 

NEW QUESTION 35
......

Pass Your H35-561-ENU Exam Easily with Accurate PDF Questions: https://passking.actualtorrent.com/H35-561-ENU-exam-guide-torrent.html